KNX DALI GATEWAY - 2 CHANNELS - TUNABLE WHITE DT6, DT8

The DALI Gateway IC02D01DAL is a device used to control electronic ballasts (ECGs) with a DALI interface (in accordance with EN 62386) via the KNX installation bus. The device converts switching and dimming commands from the connected KNX system into DALI telegrams and status information from the DALI bus into KNX telegrams. The IC02D01DAL is equipped with two DALI outputs which are independent from one another. 64 ECGs can be controlled individually or in up to 16 DALI groups via each output. Both outputs offer the full range of functions described below. The IC02D01DAL is a so-called Single Master Application Controller (according to EN 62386-103). This means the device must only be used in DALI segments with connected ECGs and not with other DALI control devices within the segment (no multi-master operation). The required power supply for the up to 64 connected ECGs comes directly from the IC02D01DAL. An additional DALI power supply is not required and not permitted. Supported are ECGs according to EN 62386-102 ed1 (DALI version-1) as well as devices according to EN 62386-102 ed2 (DALI-2). IC02D01DAL is certified according to EN 62386-101 and -103 ed2 (DALI-2) and therefore entitled to bear the DALI-2 logo. The device comes is intended for installation on DIN rail in LV distribution switchboards. In addition to the pure gateway function, the DALI gateway IC02D01DAL also offers numerous additional functions • Addressing of up to 16 DALI groups • Flexible DALI commissioning concept in the ETS5 • Coloured light control with the help of device type 8 ECGs • Coloured light control depending on ECG sub-type: – Colour temperature (DT-8 Sub-Type Tc) – XY colour (DT-8 Sub-Type XY) – RGB (DT-8 Sub-Type RGBWAF) – HSV (DT-8 Sub-Type RGBWAF) – RGBW (DT-8 Sub-Type RGBWAF) - DT-8 Sub-Type PrimaryN is not supported • Support of time scheduling programmes to control groups according to values and/or colour • Different operating modes such as permanent mode, night-time mode or staircase mode • Integrated operating hours counter for each group with an alarm for when the maximum life-span has been reached • Individual fault recognition with objects for each light/ECG • Complex fault analysis at group/device level with number of faults and fault rate calculation • Fault threshold monitoring with individually configurable threshold values • Scene module for extensive scene programming • “Quick exchange function“ for easy replacement of individual faulty ECGs • Manual control of group and broadcast telegrams via control buttons on the device (see application program description for operating instructions) • Signaling of a fault status via LEDs on the device (see application program description) DALI devices for individual battery emergency lights of device type DT-1 can be read by the gateway IC02D01DAL and switched and controlled via DALI telegrams. However, DALI commands to start and export test results are not supported. The special surface for the configuration of DALI segments is designed as DCA (Device Control App) for the ETS5. Please remember to install the corresponding etsapp in addition to the product database knxprod.